1. Oil pan
2. Screw, 16 Nm: replace; 5 pcs.; for fastening the oil pan with the oil pan seal on the gearbox housing
3. Seal: replace
4. Screw, 5 Nm + turn 90° (¼ turn): 10 pcs.; replace; for fastening the mechatronics for the dual clutch gearbox "J743" to the gearbox housing. Observe the sequence when loosening and tightening
5. Mechatronics for dual clutch gearbox "J743": Mechatronics is identified by the gearbox letter designation; with O-ring seals on the connector. Replace the O-ring seals
6. Automatic transmission DSG
7. Ventilation tube: pressed into the gearbox; replace
8. Breather: put on the tube to remove air
9. Nut, 20 Nm: replace
10. Gear shift lever: install so that the interrupted pitch of the teeth matches the gear shift rod
11. Shift Rod O-Ring: Installation Position: Lettering should face outward toward shift lever/control shaft; replace
12. Screw, 20 Nm + turn 90° (¼ turn): for fastening the transmission oil cooling radiator to the gearbox housing; replace
(Source of the article web resource: SKODABOOK.ru)
13. Transmission oil cooling radiator
14. Replace O-rings: replace
15. Drive cable counter support: for control lever drive cable
16. Screw, 20 Nm + turn 90° (¼ turn): replace; 2 pcs.; for fastening the cable support to the gearbox housing
17. Filter housing, 20 Nm
18. O-ring seal: replace
19. Transmission oil filter: Replace at every oil change. Pay attention to the installation position
20. Input shaft torque sensor "G182" with clutch temperature sensor "G509"
21. Screw, 10 Nm; replace
22. Mounting pin: 2 pcs.; for fastening the transmission oil pump to the gearbox housing
23. Seal: replace
24. Transmission oil pump
25. Transmission oil pump cover: with vulcanized seal; replace
26. Screw, 8 Nm: replace; 4 pcs.; for fastening the cover to the gearbox housing
27. Screw: replace; 4 pcs.; for fastening the transmission oil pump to the 1st gearbox housing; loosen and tighten in a crisscross pattern
28. Sealing ring: absent.
29. Drain plug, 45 Nm: missing, drain oil through the oil level inspection hole "pos. 32"
30. Bypass tube, 3 Nm; made of plastic. The length of the bypass tube determines the oil level in the gearbox; when replacing this tube, observe the part number
31. O-ring: replace
32. Threaded plug for checking the oil level, 45 Nm: Behind this plug there is a bypass tube, tightened using an 8 mm internal Allen key, "pos. 30".
33. Screw, 32 Nm: 4 pcs.; for fastening the protective cover to the gearbox housing
34. Heat Shield: Fitted on some transmissions.