Contents: Removal ⬇ Installation ⬇
Removal
1. Chock the rear wheels, firmly apply the parking brake, then jack up the front of the vehicle and place it on stands. Remove the appropriate front wheel.
2. Loosen the nut securing the stabilizer bar strut to the lower suspension arm, remove the washer and the lower support cushion.
3. Release the strut from the lower arm, then remove the upper support cushion with the washer. The strut can now be removed from its end of the stabilizer bar.
4. Check the rack components for signs of wear and mechanical damage. Particular attention should be paid to the condition of the rubber pads of the supports and bushings. Replace defective components.
[Information published on the website: skodabook.ru]
Installation
1. Place the strut on the stabilizer bar, install the washer and rubber cushion of the upper support.
2. Insert the strut into the lower suspension arm, install the rubber cushion and the lower support washer. Screw on the fastening nut. Make sure that the strut is positioned correctly, then tighten the nut to the required force.
3. Replace the wheel, lower the vehicle to the ground and tighten the wheel bolts to the required torque.