Contents: Cars with gasoline engines ⬇ Diesel-powered vehicles ⬇ Replacing the fuel filter (diesel…⬇ Installation ⬇ Replacing the air filter element ⬇ Replacing the dust and odor filter ⬇
Cars with gasoline engines
Cars with replaceable oil filters
Loosen the oil filter and remove it. Clean the sealing surface on the engine. Lightly lubricate the rubber seal with oil. After screwing on the new filter, tighten it by hand. After adding oil, check the engine for leaks when it is warmed up to operating temperature.
Cars with a replaceable oil filter element
Release the lid. Replace O-rings "2" and filter element "3". Tighten cover "1" to 25 Nm.
After adding oil, check the engine for leaks when it is warmed up to operating temperature.
Diesel-powered vehicles
Loosen cap "1". Replace O-rings "2" and "3" and filter element "4". Tighten cap "1" to 25 Nm. After adding oil, check the engine for leaks when it is warmed up and at operating temperature.
Replacing the fuel filter (diesel engines)
Important: Make sure that diesel fuel does not come into contact with the coolant hoses. Otherwise, the hoses must be cleaned immediately!
Loosen the spring clamps for hoses "3". Remove fuel hoses "1" (inlet) and "2" from the terminals on the filter.
Remove retaining clamp "4". Remove control valve "5" with attached fuel lines. Release the "arrow" fasteners. After releasing the filter fastener, remove the filter.
Installation
Put on a new filter. Secure the "arrow" clips. Install a new O-ring for the control valve. Install the control valve "5" with the fuel lines connected. Install retaining clamp "4". Place fuel hoses "1" (inlet) and "2" onto the filter terminals and secure them with spring clamps "3".
Important: The direction of flow is indicated by arrows (do not confuse the connections).
Check the tightness of the fuel system (visual control).
Replacing the air filter element
Open the filter housing. Replace the filter element and clean the housing. After closing the filter housing, check that it is installed correctly.
Replacing the dust and odor filter
Release the dust and odor filter clips on the Strelka heater. Remove the dust and odor filter from the Strelka heater housing. Disconnect the filter element from the filter frame. Installation is carried out in the reverse order of actions.
[Article source: this website www.skodabook.ru]
