Important: When installing, ensure that the contact terminals of the arguments are positioned correctly.
Release the retaining tabs of wiring connectors "3" and "4" and remove them. Using a screwdriver, lift retaining plates "1" and "2" and remove the fuel level sender downward "arrow".
Installation
The fuel gauge sensor "G" should be inserted into the slots on the fuel pump and pressed all the way upwards so that the retaining plates enter the locked position. Connect the locking tabs of pipes "3" and "4". Install the fuel pump.
Accelerator Pedal Module - Assembly Diagram
1 - Bearing housing (support bracket); 2 - Plug connector, six-pin, black; 3 - Accelerator pedal position sensor "G79", not adjustable, the sensor transmits the driver's will (expressed by the degree of pressing of the accelerator pedal) engine control unit, before proceeding to remove the sensor, you need to remove the lower part under the instrument panel (on the driver's side); 4 - 9 Nm