Radio receiver "Best"
Insert the extraction tool into the holes (see picture) so that it enters into a fixed position. Pull the radio out of the instrument panel by pulling on the hinges of the device.
Important: When removing the car radio, do not push the car radio extractor to the side or allow it to become tilted. To be able to pull the car radio removal tool out again, you need to press the side locking tabs on the car radio inward. Disconnect the antenna wire plug connectors.
Installation
Connect the antenna wire to the plug connectors. Carefully insert the radio into the instrument panel until it locks into place in the assembly frame. If the radio receiver has been replaced: enter the safety code and encode the radio receiver.
Important: During installation of the radio receiver, do not press the display or control buttons under any circumstances. The radio receiver may be damaged.
Radio receiver "Dance"
Using a lever-like motion of the disassembly wedge, carefully remove the plastic casing around the radio. Unscrew the four screws "2" (1.5 Nm). Remove the radio receiver "1" from the instrument panel.
Press the "arrows" on the connector connector latches.
After releasing the locking clamp "arrow", disconnect the plug connectors.
After unlocking the "arrow" plug connector of the antenna socket, disconnect it.
Installation
Installation is carried out in the reverse order of actions, and the following instructions must be observed. If the radio has been replaced: enter the safety code.