Contents: Roof antenna for car radio ⬇ Roof antenna for car radio and phone…⬇ Replacing antenna wires ⬇
For vehicles with a glass roof, the antenna is mounted at the rear and is tilted at 60 degrees from the roof plane. On vehicles with a solid roof, the antenna is located at the front and angled at 30 degrees from the roof plane. The images show a rear-mounted antenna. The pin distribution is the same for both antenna types.
Roof antenna for car radio
1 - Antenna rod, depending on the type of antenna used, the antenna rod is removable or non-removable, folding, combined with the antenna base; 2 - Antenna base; 3 - Input for antenna wire for car radio; 4 - Hexagonal nut with locking serrated washer, 3 Nm, the hexagonal nut is connected to the locking serrated washer with a plastic ring, lubricate the inside of the body roof in the area of the locking serrated washer with plastic contact grease; 5 - Roof of the body
Roof antenna for car radio and phone operation
View the original on the website SkodaBook.ru
1 - Antenna base with antenna rod, combined part; the antenna rod cannot be unscrewed, but can only be folded back. Do not leave the antenna rod unscrewed. The amplifier for the roof antenna is built into the base of the antenna; 2 - Input for antenna wire for car radio; 3 - Input for the antenna wire of the telephone preparation and the telephone service device; 4 - Hexagonal nut with locking serrated washer, 3 Nm, the hexagonal nut is connected to the locking serrated washer with a plastic ring, lubricate the inside of the body roof in the area of the locking serrated washer with plastic contact grease; 5 - Roof of the body
Replacing antenna wires
Important: Antenna wires cannot be repaired, but must be replaced with a new original part. Antenna wires must not be broken or excessively bent! The bending radius must not be less than 50 mm.
Cut off the plug connections of the faulty antenna wire. The remainder of the faulty antenna wire remains in the vehicle. Place and secure the new antenna wire in close proximity to the original wire. Check the functionality.