Removal and installation the lock cylinder
Remove the steering wheel. Remove the upper and lower steering column covers. Carefully disconnect the "arrow" plug connector of the immobilizer reading coil on the lock cylinder.
Important: The immobilizer sensing coil is attached to the lock cylinder and cannot be replaced separately.
After installing the ignition switch key, turn the lock cylinder so that the mark on the reading coil "1" is opposite the hole in the lock cylinder "2".
Insert steel wire (approx. 0 1.2 mm) into hole "2" next to the key. Having unfastened the locking lever "3" of the "arrow" lock cylinder using steel wire "2", remove the lock cylinder with the inserted key from the steering wheel shaft lock.
Installation
Insert the ignition switch key into the lock cylinder, turn it and insert the steel wire. Insert the lock cylinder into the steering wheel shaft lock.
Important: When inserting the lock cylinder, please note that the ignition switch and instrument panel wire contains a connector for the immobilizer reading coil. If the lock cylinder with the reading coil is replaced together with the keys, then it is necessary to adapt the immobilizer.
Connect the plug connector to the immobilizer reading coil. Install the upper and lower steering shaft covers.
(Information published on the website: «www.skodabook.ru»)