Warning: Before starting work, turn off the relevant lights.
Headlight block
Removing
1. Working in the engine compartment, disconnect the electrical wiring from the headlight and front turn signal (photo).
2. Disconnect the headlamp leveling actuator from the rear of the headlight assembly (Chapter 17).
3. Unscrew the three fixing nuts, and remove the headlight assembly (photo).
Installation
4. Install in the reverse order of removal. Check light beam direction adjustment if necessary (Chapter 16).
Front turn signal
5. The front turn signal is an integral part of the headlight unit. See above for removal and installation procedure.
Side turn signal repeater
6. Be guided Chapter 13.
Assembling the rear lights
Removing
7. Remove the lamp holder of the rear light assembly (Chapter 13).
8. Unscrew the three mounting nuts, marking the ground points, and remove the group (photo).
Installation
9. Install in the reverse order of removal.
Rear fog lamp and reversing lamp
Removing
10. Open the tailgate and remove the interior trim panel (Section 11) and a plastic membrane.
11. Remove the plastic caps from the mounting nuts, and unscrew the nuts, marking the ground points.
12 Carefully separate the lamp units from the tailgate, and disconnect the electrical wiring connectors.
Installation
13. Install in the reverse order of removal.
License plate light
Removing
14. The license plate light units are located on the outer rear door trim panel.
15. Remove diffuser and lamp (Chapter 13), then use a small flathead screwdriver to carefully pry the unit away from the tailgate trim panel.
16. Disconnect the wiring and remove the block.
Installation
17. Install in the reverse order of removal.