Assembly diagram of the trunk lid
- 1 - Trunk lid
- 2 - Rubber adjustment buffer
- 3 - Spherical pin - 20 Nm
- 4 - Gas-filled shock absorber (stop)
Gas-filled shock absorber "1". Retaining clamp "2". Ball joint "3". Installation should be carried out in the reverse order of actions.
Assembly diagram of the trunk lid lock
- 1 - Nut 6 Nm
- 2 - Cup (bar) for fastening
- 3 - License plate light
- 4 - Trunk lid opening grab handle bar
Remove the trunk lid trim (panel). Disconnect the connector from the strip. After removing the nuts (item 1), remove the mounting cup (item 2). Installation should be carried out in the reverse order of actions.
- 5 - Expansion nut
- 6 - Trunk lid lock
Remove the trunk lid trim (panel). Disconnect the lock plug connector. After removing the support screws (pos. 7), remove the lock. Installation should be carried out in the reverse order of actions.
- 7 - 20 Nm
- 8 - Eye of the locking device. The lid must fit well to the body. It is necessary that the lid opens and closes freely.
- 9 - 20 Nm