Removal and installation the actuator motor for regulating the central air distribution flap (Skoda Fabia 5J)

Remove the instrument panel. By pressing the latch "2", tilt the actuator motor to adjust the position with the holder to the right side to such an extent that the handles do not enter the guide grooves. Pull the actuator motor for position adjustment with the holder out of the mount "3" towards you. Disconnect plug connector "1".

Installation

Connect plug connector "1". The holder with the actuator motor for position adjustment should be inserted into the mounting point "5". Handle "1" should be inserted into guide groove "2", and lever "3" should be inserted into guide groove "4" of the actuator motor for position adjustment.



The holder with the actuator motor for position adjustment should be fixed in the distributor housing "2". Check the installation of the levers in the guide grooves of the actuator motor for position adjustment.



(View the original on the website: «SkodaBook»)

Important: If the actuator motor for position control has been changed, it must be reset to its original position.