Removal and installation the spray nozzle holder
If only the spray nozzle holder is removed, there is no need to remove the bumper. Spray nozzles with cap 1 - should be pulled out a little from the bumper by grasping the cap evenly on both sides in your hand, then grab the washers and pull them out until they stop. Cap "1" should be squeezed out of the clamps of the "arrow" support on the spray nozzle holder.
Slightly lift the "arrow" lock and pull out the spray nozzle holder.
Installation
Important: The locking devices on the spray nozzle holder can be used to adjust the degree to which the spray nozzle cap is inserted into the bumper. If the spray nozzle holder is inserted too deeply into the washer cylinder, the cap or bumper may become deformed. If the spray nozzle holder is inserted into the washer cylinder too little, a gap will remain between the cap and the bumper.
Secure the cap to the holder using the clamping clips. The holder together with the cap should be inserted into the washer cylinder so that the cap fits tightly against the bumper. After installing the holder, you should remove air from the headlight washers.