Contents: Installation ⬇ Tightening torque ⬇ Assembly diagram - hydraulic system ⬇ Distinguishing O-rings ⬇
Remove the lower cover on the driver's side. Remove the safety support "arrow" in front of the clutch pedal (if it is installed). Remove the clutch pedal switch, if equipped. Disconnect the clutch master cylinder control rod from the clutch pedal.
The control rod of the master cylinder of the clutch drive booster is disconnected from the clutch pedal as follows: Insert the pliers into the recesses of the clutch pedal. Press the fastener and disconnect the clutch pedal from the clutch booster master cylinder. Remove the return spring. Adjust the steering wheel to the lower position.
After unscrewing nut "A", remove the screw from the pedal support (installation) (to facilitate removal of the screw, slowly turn the steering wheel to a suitable position). Remove the clutch pedal.
Installation
Installation is carried out in the reverse order of actions, and the following instructions must be observed.
Mount "A" must be located on control rod "B" of the clutch control booster master cylinder. For correct installation, press the clutch pedal against the front bulkhead separating the engine bay from the passenger compartment "arrow direction", ensuring proper locking.
Build in a switch for the clutch pedal.
Install the safety support "arrow" in front of the clutch pedal. Remove the lower cover on the driver's side.
Tightening torque
| Design detail | Tightening torque |
| Safety support | 9 Nm |
Assembly diagram - hydraulic system
1 - Brake fluid reservoir; 2 - Supplementary hose; 3 - Clutch master cylinder*, after installing the clutch system, air must be removed from it; 4 - Bracket; 5 - Fastening, replace only with the clutch actuator master cylinder removed, pos. 3; 6 - Clutch pedal; 7 - 28 Nm; 8 - O-ring, lubricate with brake fluid before installation; 9 - Pipe and hose line; 10 - Holder, on the longitudinal beam in front to the left, for attaching the pipe and hose line pos. 9; 11 - Holder, holds the pipe and hose line pos. 9 on the gearbox; 12 - 20 Nm; 13 - Air valve; 14 - Dust cover; 15 - Clamp, when removing the pipe and hose line pos. 9 pull it out of the clutch booster working cylinder until it stops; 16 - Gearbox; 17 - Clutch release drive slave cylinder, after installation, air must be removed from the clutch system
Remove fastener "A" in the direction of the arrow.
Installing the control rod and the main cylinder of the control amplifier of the snubber drive into the "A" mount in the "direction of the arrow".
Distinguishing O-rings
- -1 - connecting element of the wire with an annular groove "arrow 1"
- "2" wire connecting element with shoulder "arrow 2"
