Removal and installation the return spring (Skoda Fabia 5J)

Remove the lower cover on the driver's side. Remove the safety support (if it is installed). Remove the clutch pedal switch, if equipped. Disconnect the clutch master cylinder control rod from the clutch pedal. The control rod of the master cylinder of the clutch drive control booster is disconnected from the clutch pedal as follows:

Insert the release pliers into the recesses of the clutch pedal.



Press the fastener and disconnect the clutch pedal from the clutch booster master cylinder. Press the return spring against the waterproof casing - in the direction of the arrow - and remove it from the support from the bottom side.

Installation

Insert the support (fastening) for the return spring "arrow 1" into the support bracket. The support protrusion is located in the recess of the master cylinder of the clutch drive control booster "arrow 2". Install the return spring in the support (attachment point). Pressing the return spring against the support, place it on the clutch pedal bracket "arrow".





Connect the clutch pedal to the brake master cylinder. Build in a switch for the clutch pedal.



Install the safety support. Remove the lower cover on the driver's side.