With the ignition off, disconnect the wire connecting the battery terminal to the ground (body) of the vehicle. Remove the air filter. Remove the battery battery holder. After removing the additional hose "A" leading to the hydraulic brake drive receiver, plug it.
Remove the safety clip "B" from the clutch booster master cylinder. After removing the pipe and hose line "C" from the master cylinder of the clutch drive control booster, seal it. Remove the lower cover on the driver's side. Remove the clutch pedal safety support (if it is installed) Remove the clutch pedal switch, if equipped.
Important: To remove the clutch master cylinder, the clutch pedal assembly must be completely removed. However, before you begin removing it, you need to disconnect the clutch booster master cylinder from the clutch pedal.
Disconnect the clutch master cylinder control rod from the clutch pedal. The clutch booster master cylinder control rod is disconnected from the clutch pedal as follows: Insert the release pliers into the recesses of the clutch pedal. Press the fastener and disconnect the clutch pedal from the clutch booster master cylinder. Remove the return spring.
Having unscrewed the nuts "arrow 1", completely remove the clutch pedal mechanism "arrow A" with the master cylinder of the clutch drive control booster. Unscrew the pedal stop.
Installation
Installation is carried out in the reverse order of actions, and the following instructions must be observed. Mount "A" must be located on control rod "B" of the clutch control booster master cylinder.
For correct installation, press the clutch pedal against the front bulkhead separating engine bay from cabin "arrow direction"; in this case, it is necessary to ensure proper locking.
After installing the clutch booster master cylinder, bleed the air from the clutch system.