Installation
Installation is carried out in the reverse order of actions, and the following instructions must be observed. Mount "A" must be located on control rod "B" of the clutch control booster master cylinder.
For correct installation, press the clutch pedal against the front bulkhead separating engine bay from cabin "arrow direction"; in this case, it is necessary to ensure proper locking.
Assembly diagram - hydraulic system
1 - Brake fluid reservoir; 2 - Supplementary hose; 3 - Clutch master cylinder, after installing the clutch system, air must be removed from it; 4 - Safety clamp, when removing the pipe and hose line - pos. 9 pull it out of the master cylinder of the clutch drive control booster - pos. 3; 5 - Fastening, replace only with the clutch actuator master cylinder removed - pos. 3; 6 - Clutch pedal; 7 - 28 Nm, always replace; 8 - O-ring, always replace, lubricate with brake fluid before installation; 9 - Pipe and hose line; 10 - Holder, on the longitudinal beam in front to the left, for attaching the pipe and hose line - pos. 9; 11 - Holder, holds the pipe and hose line - item 9 on the gearbox; 12 - 20 Nm; 13 - Safety clamp, for removing the pipe and hose line - pos. 9, pull it out of the clutch booster working cylinder as far as it will go - pos. 16; 14 - Dust cover; 15 - Air valve; 16 - Clutch release drive slave cylinder, after installation, air must be removed from the clutch system; 17 - Gearbox
Remove fastener "A" in the direction of the arrow.
Installing the control rod and the master cylinder of the clutch drive control booster into the "A" mount in the "direction of the arrow"
Distinguishing O-rings
- -1 - connecting element of the wire with an annular groove "arrow 1"
- "2" wire connecting element with shoulder "arrow 2"
