Contents: Removal and installation levers with…⬇ Installation ⬇ Removal and installation the…⬇ Removal and installation the…⬇ Installation ⬇
Removal and installation levers with brushes and adjusting their end position
Using a screwdriver, remove both nut caps on the windshield wiper arms. After loosening the arrow nuts, fold back the windshield wiper arms and release them from the cone with lateral movements. After this, completely unscrew the nuts and remove the wiper arms.
Installation
After turning on the windshield wiper motor, turn it off and leave it to coast to the end position. Putting on the windshield wiper arms (the driver has a shorter lever), align the wiper blades with the "1" marks on the windshield. Tighten the lock nuts. Check the operation of the windshield wipers, if necessary, align the windshield wiper arms again and tighten the lock nuts (20 Nm).
Important: The tolerance between the wiper blade and the "1" mark is ±3 mm.
Removal and installation the windshield wiper motor with a lever mechanism
Remove the windshield wiper arms with blades. Remove the waterproof casing cover and protective grille. Unscrew the two support screws "1" (7 Nm). Disconnect the plug connector "2" from the windshield wiper motor. The windshield wiper motor should be moved towards the motor "arrow", pulled out of the retaining pin "3" and removed together with the lever mechanism.
Installation is carried out in the reverse order of actions.
Removal and installation the windshield wiper motor from the linkage mechanisms
Using a large screwdriver, disconnect linkage mechanisms "1" and "5" from the ball joint "4". Using an open-end wrench, slightly rotate linkage handle "3" "arrow" and unscrew fastening bolts "2".
Installation
Installation is carried out in the reverse order of actions, and the following instructions must be observed. After tightening the screws and installing the lever mechanism on the hinged grip, use an open-end wrench to return handle "3" to its original position (the axis of the handle is parallel to the lever mechanism and the hinged grip of the lever mechanism "4" is directed towards the windshield wiper motor).