- A - 14-pin plug connector
- B - Wiring harness for 14-pin plug connector
Removal the wiring harness with a 14-pin plug connector
With the ignition off, disconnect the wire connecting the battery terminal to the ground (body) of the vehicle. Remove the oil pan. Remove the mesh oil filter. Remove the valve box.
In case of integrated gearbox
Disconnect the 14-pin plug connector "A" from the plug connector on the transmission.
All
Remove the retaining screw of the 14-pin plug connector on the outside of the transmission housing. After removing the plug connector from the gearbox housing, carefully thread the "D" wire harness through it.
Installing a wiring harness with a 14-pin plug connector
Installation is carried out in the reverse order of actions; in this case, the following instructions must be observed. Replace the O-ring on the plug connector. Lubricate the O-ring with ATF. Press the connector with the O-ring installed into the gearbox until it stops.