Important: It is also possible to remove and install the filter without having to remove the shock absorber panel. There is also a combination filter. It has a built-in filter to absorb odors. Removal and installation of this filter are the same. The filter element and frame form a single component.
Slide locks "1" to the center until stop "arrows". Remove filter cover downward "3". Remove dust and pollen filter downward "2".
Installation
Installation is carried out in the reverse order of actions. In this case, the following instructions must be observed. Before you begin installation, please check the assembly position. The top and bottom plates of the filter element must lie in the frame. Both arrows on the frame and on the filter element indicate the direction of flow. The frame grille must be directed towards the distributor housing. The filter cover "3" must be properly installed in the housing, properly seated, and the sliding locking parts "1" must be pushed out as far as they will go.
(Material is available on the website: SkodaBook.ru)