Important: Mounting bracket for flexible shaft of mixing adjustment device (temperature) the damper is the same as the mounting bracket for the flexible shaft of the air distribution damper adjustment device.
Remove the instrument panel. After locking the flexible shaft by pressing on the plastic section of the flexible shaft "2" in the direction of the "arrow", pull it out of the heater control device.
Using a blunt screwdriver, press in the plastic protrusion "arrow" of the adjusting device "2" and pull out the flexible shaft "1".
Installation
Flexible shafts are installed on the adjustment devices and on the heater control device in only one single position. During installation, it is necessary that the adjustment devices and rotary control buttons on the heater control device are in a certain relative position. Otherwise, the heater would not operate properly.