Disassembling and assembling the engine (Skoda Fabia 5J)

1 - 90 Nm + turn an additional 1/4 turn (90°), replace, the contact surface of the fastening screw must be free of oil and grease; 2 - Crankshaft pulley, mating surfaces must be free of oil and grease; 3 - 20 Nm; 4 - Liquid cooling system pump pulley; 5 - 10 Nm; 6 - Liquid cooling system pump; 7 - 25 Nm; 8 - 23 Nm; 9 - V-ribbed belt tensioner; to release the V-ribbed belt, move it aside using an open-end wrench; in a relaxed position, it may be fixed with a 4 mm hex socket wrench; 10 - Alternator, to make installation easier, you should push the threaded bushings of the screws on the alternator back a little; 11 - Before removing the poly V-belt, mark the direction of movement with chalk or a felt-tip pen, do not bend it excessively

1 - Poly V-belt tension roller, fold the tension roller back using a ring spanner, 4 mm spanner into the locking hole; 2 - Auxiliary unit mounting bracket; 3 - 50 Nm, tightening order: first tighten the screw to the right at the top, then the screw to the right at the bottom and finally the screws to the left (when viewed in the direction of vehicle movement); 4 - 23 Nm; 5 - Alternator To make installation of the alternator easier, you should push the threaded bushings of the support screws on the alternator back a little; 6 - 20 Nm + turn an additional 1/4 turn (90°), M10: 45 Nm; 7 - Bushing, 2 pcs.; 8 - 25 Nm; 9 - Air conditioning compressor; 10 - Poly V-belt, before you start removing the belt, you need to mark the direction of its movement with chalk or a felt-tip pen; 11 - Poly V-belt pulley; 12 - 90 Nm + turn an additional 1/4 turn (90°), replace, additional turning can be done in several steps