Important: The areas under the bushings and sliding surfaces must be lubricated with grease "G 000 450 02". There is no mechanical safety device with a drawbar to prevent the ignition key from being removed, but an electrical safety device to prevent the ignition key from being removed.
1 - Gearshift mechanism housing; 2 - Spacer; 3 - 25 Nm, 4 pcs, for attaching the gearshift mechanism to the body; 4 - Gear shift mechanism (support bracket), with a built-in printed circuit board of the gear shift mechanism, do not touch the board, if the Tiptronic "F189" device switch is faulty, then the gear shift mechanism must be replaced; 5 - Electromagnet for locking the preselector lever "N110", checked by the automatic control system; 6 - Replace the locking clamp for cable tightening of the preselector lever on the support bracket; 7 - Gearshift cover, with glued seal; 8 - 9 Nm, self-locking, for securing the cover on the gearshift mechanism, 4 pcs, replace; 9 - Preselector lever cable tightening, do not bend or over-bend, if the protective cover is damaged, it is necessary to replace the preselector lever cable tightening, check and adjust, do not lubricate the fastening loop and spherical insert; 10-13 Nm, for the holder - pos. 11 on the gearbox; 11 - Holder, cable tightening of the preselector lever; 12 - 23 Nm, for support on the gearbox, 2 pcs; 13 - Counter support, cable tightening of the preselector lever on the gearbox