Side console in driver's door armrest
1 – the button of management of a window regulator of a back right door;
2 – the button of management of a window regulator of the left back door;
3 - door lock button;
4 – the button of blocking of the electric drive of back doors;
5 – the button of management of a window regulator of a forward right door;
6 - button for unlocking the central lock;
7 - button for locking the central lock;
8 – the button of management of a window regulator of a forward left door
In the side consoles on the doors there are buttons 1, 2, 5 and 8 for controlling power windows (in the rear doors on request).
The electric drive works at the included ignition. But it can also be used after turning off the ignition for approximately 10 minutes, provided that the doors are not opened during this time.
1. To lower the door window glass, lightly press the corresponding button and hold it in this position. When the button is released, the glass will stop. If you press the button all the way, the window will lower even when the button is released. You can stop the glass by pressing the button again.
2. To raise the glass of the door window, slightly lift the front of the corresponding button and hold it in this position. If you lift the button all the way, the glass will rise even when the button is released. You can stop the glass by pressing the button again.
3. When button 4 is pressed, the electric drive of the rear doors is blocked. By pressing this button again, you can use the electric rear doors again.
The glass control system is equipped with a lock that stops the closing of the glass when an obstacle is encountered in its path. If any obstacle interferes with the closing of the glass, it will stop and open slightly.
The windows can be opened or closed when the doors are closed with the key. To close, turn the key in the lock to the door close position and hold it in this position until the windows close. When the key is released, the windows will immediately stop. When the key is held in the open position, the windows open. When opening and closing the windows with the key, the windows are blocked.
Attention! Remember that when closing the windows with the key, they cannot be opened from the inside 10 minutes after the ignition is turned off or after the driver's door is opened with the ignition off.
If the battery is disconnected, the glass control system must be reconfigured. To do this, with the ignition on, close all windows with the key. Then release the key for a few seconds and turn it again to the door close position and hold it in this position for 3 seconds.
With increased resistance to glass movement (snow ingress, freezing, etc.) you can control the glass with a key. If the window stops when closing, release the key for a few seconds and try closing the window again.