Contents: Repair of the front wheel brake…⬇ Assembly diagram of the front wheel…⬇ Removal ⬇ Installation ⬇
Repair of the front wheel brake mechanism, FS-II disc wheel brake caliper
Important: After replacing the brake pad friction linings, you should press the brake pedal firmly several times with the vehicle stationary to ensure that the friction linings are in their working position. Before you begin removing the brake caliper or disconnecting the brake hose from the brake caliper, you must secure the brake pedal with a device (spacer bar) to hold the brake pedal. To suck out brake fluid from the hydraulic brake reservoir, use an air removal vessel that comes into contact only with the brake fluid. Brake fluid that has already been used cannot be reused. Tightening torque of wheel mounting bolts: 120 Nm.
Assembly diagram of the front wheel brake mechanism FS-II
- 1 - Brake disc, wear limit: 15 mm, replace on both sides of the bridge, before proceeding with removal, you need to unscrew the caliper of the disc wheel brake mechanism
- 2 - Screw, 4 Nm
- 3 - Friction linings (segments), with wear indication, when wear is appropriate (border: 2...3 mm) the indicator on the instrument panel is on, wear limit: 2.0 mm without the support plate, replace on both sides of the bridge in principle
- 4 - Disc wheel brake support
Removal
Remove the friction linings. Install the brake pedal holding device. Unscrew the brake hose from the disc brake caliper.
Installation
Install friction linings. Screw the brake hose onto the disc brake caliper. Remove the brake pedal holding device. Bleed the brake system.
(Material published on the website SkodaBook.ru)
- 5 - Before installing the lower rubber bushing, lubricate it with lithium-containing grease "G 052 150 A2"
- 6 - The lower bushing is notched on one side; before installing it, lubricate it with lithium-containing grease "G 052 150 A2"
- 7 - Before installing the lower spacer sleeve, lubricate it with lithium-containing grease "G 052 150 A2"
- 8 - Cylindrical screw with internal hexagon in the head, lower, 25 Nm, M8x48
- 9 - Air duct
- 10 - Screw, 10 Nm, for air duct
- 11 - Hexagon socket head cap screw, top, 25 Nm, M8x59
- 12 - Lubricate the upper spacer sleeve with competitive lithium-containing grease "G 052 150 A2" before installing it
- 13 - The upper bushing is notched on one side; before installing it, lubricate it with lithium-containing grease "G 052 150 A2"
- 14 - Before installing the upper rubber bushing, lubricate it with lithium-containing grease "G 052 150 A2"
- 15 - Elastic bushing
- 16 - Brake hose with nipple, hollow screw and sealing rings, do not disassemble, replace only one piece, as a set, tightening torque: 35 Nm
- 17 - Wheel hub with wheel hub bearing, for vehicles with ABS, pulse sensor sensor disc (pulse ring) built into the wheel hub
- 18 - Screw, 10 Nm
- 19 - Protective sheet
- 20 - Wheel hub bearing cap
- 21 - ABS speed sensor
- 22 - Hexagon socket head cap screw, 8 Nm, for ABS speed sensor