Removal the coil spring
Removing the shock absorber strut. Pre-tension the coil spring using a coil spring compressor to such an extent as to relieve the load from the shock absorber strut section "3".
Loosen the nut on the piston rod using a tubular wrench, while holding it (locking) using a 2 mm hex socket wrench. Remove individual parts of the shock absorber strut and the compressed coil spring using a coil spring compression tool.
Installing a coil spring
The pre-tensioned coil spring should be installed using a coil spring compressor onto the lower spring seat.
[The article is located on the website Skodabook.ru]
The end of the coil spring should rest against the "arrow" stop. Reinstallation is then carried out in reverse order.
Tightening torque
| The shock absorber support nut on the piston rod | 60 Nm |