Contents: Installation ⬇ Tightening torques ⬇
Remove the lower engine cover. Unscrew screws "1" and "2" of the rocking support.
Unscrew the stabilizer mounting bracket from the arrow bracket.
Important: The stabilizer mounting bracket is located behind the bracket and is not visible in the picture. The lower screw of the right bracket can only be removed by lowering the suspension mounting beam.
Unscrew nuts "1" to the left and right. Remove the stabilizer connecting rod "3" to the left and right from the stabilizer "2".
After unscrewing screws "1", attach (hang) the steering gear housing, e.g. wire in such a way that its position for assembly is maintained. After releasing the suspension mounting beam, lower it. Remove the mounting bracket from the stabilizer. Turn the stabilizer upwards and remove it towards the rear.
Installation
Install the stabilizer. After inserting the new screws for the mounting bracket, tighten them by hand.
Data taken from an online portal: www.SkodaBook.ru
Important: Before installing the suspension mount beam mounting screws, the power steering housing must be installed onto the suspension mount beam and the power steering housing screws must be tightened.
After lifting the axle suspension mounting beam, screw it in place. Further installation is carried out in the reverse order of actions, and it is necessary to observe the following instructions: After installing the rocking support on the gearbox, tighten it with new screws "1".
Important: Place bolts "1" into the slots of the rocker support so that there is maximum distance between the gearbox and the axle suspension mounting beam.
Install the lower engine cover.
Tightening torques
| Power steering housing on the suspension mounting beam | 50 Nm + 90° |
| Bracket on the body | 70 Nm + 90° |
| Support on the body | 20 Nm + 90° |
| Bracket on the suspension mounting beam/body | 50 Nm + 90° |
| Rocker support on the gearbox | 30 Nm + 90° |
| Stabilizer connecting rod on the stabilizer | 40 Nm |
| Stabilizer clamp on the bracket | 20 Nm + 90° |