Contents: Installation ⬇ Tightening torques ⬇
Remove the rear wheel. Release the cap from the seat (attachment points) with light blows on the lid puller.
Remove the cap.
After unscrewing screws "A", remove the disc brake caliper and hang it up, for example. using wire on the body.
Important: To remove the disc brake caliper, you do not need to unscrew the brake hose.
After unscrewing the brake disc fixing screw, remove the brake disc. Unscrew the twelve-sided nut. Remove the wheel hub with wheel hub bearing from the axle stub (journal).
Caution: Be careful not to damage the ABS device impulse ring.
Installation
Carefully place the wheel hub with the bearing onto the axle journal (neck) until it stops.
Important: Do not allow the wheel hub with the bearing to jam (skewed) on the axle journal. Use a new twelve-sided nut. The cap should be replaced after each removal. Damaged caps allow moisture to penetrate inside.
After screwing on a new twelve-sided nut, tighten it. After installing the brake disc, secure it with a screw.
After installing the disc brake caliper, tighten screws "A". Press in the cap. After installing the wheel, tighten it.
Tightening torques
| Brake shield (brake shoe holder) with a disc brake caliper - welded axle beam | 30 Nm + 30° | |
| Twelve-sided nut - axle journal (neck) | 70 Nm + 30° | |
| Brake disc fixing screw - wheel hub | 4 Nm | |
| Wheel mounting bolts | 120 Nm |
(The article is located on the website SKODABOOK.RU)