Contents: Fuel tank with installed parts ⬇ Fuel pump/fuel gauge reader flange…⬇ Air valve control ⬇ Assembly diagram of the fuel filter ⬇
Fuel tank with installed parts
1 - Cork; 2 - Seal; 3 - Fuel tank filler cap module, with dust cover; 4 - Gravity valve, to remove, release the valve from the clamps by pulling it upwards, check the valve capacity: valve - in a vertical position: valve is open, valve - at an angle of 45°: valve is closed; 5 - "Ground" connection; 6 - 10 Nm; 7 - Air bleed tube, secured to the fuel tank; 8 - 25 Nm; 9 - Fuel tank; 10 - Tightening band clamp; 11 - Fuel (fuel pump) pump, with fuel gauge sensor "G"; 12 - Replace the sealing ring. To install the fuel pump flange, wet it with fuel only on the inside; 13 - Union nut, removal and installation - using the key "MP 1-227 (3217)"; 14 - Fuel supply line to the fuel filter, ensure secure installation, black; 15 - Return fuel line, check for tightness of installation, blue; 16 - Air valve, to remove, release the valve on the pipe from the clamping clamps by bending it to the side, before starting installation, unscrew the cover; 17 - O-ring seal, replace
Fuel pump/fuel gauge reader flange assembly position
The markings on the flange must match the markings on the fuel tank "arrows". Fuel supply line (black) "1" to the connector marked "V". Fuel return line (blue) "2" to the connector marked "R".

Important: After installing the fuel pump of the fuel gauge, check that the supply and residual fuel lines are secured with clamps to the fuel tank.
Air valve control

- The lever is in its original position: the valve is closed
- The lever is pressed in the direction of the arrow: the valve is open
Article posted on the website SkodaBook
Important: Before installing the air valve, unscrew the fuel tank filler cap.
Assembly diagram of the fuel filter
The direction of fuel flow is indicated by arrows on the hoses and on the fuel filter.
1 - Inlet hose to tandem pump, white marking; 2 - Fill the fuel filter before installing it, do not mix up the connections, replace if damaged, when removing it, disconnect the fuel supply line, press the clamps of the plastic casing outward and remove the fuel filter upwards; 3 - Connecting hose; 4 - Drain hose, to the fuel tank, blue marking; 5 - Drain hose, from a tandem pump, blue marking; 6 - Combination valve; 7 - Supply hose, from the fuel tank, white marking; 8 - 25 Nm; 9 - Holder; 10 - Plastic casing, with the holder forms a single spare part
