Assembly diagram
1 - Defrost heater grille, built into the instrument panel; 2 - Central instrument panel air vent with hazard warning light switch; 3 - Instrument panel; 4 - Side window defrosting grille; 5 - Side instrument panel air vent, carefully remove using a lever action of the mounting wedge at the top and bottom (similar to the middle instrument panel air vent); 6 - Spacer (air duct) for defrosting the heater grilles, it is secured to the heater with mounting pins; to remove it, you need to remove the instrument panel; 7 - Middle part of the instrument panel; 8 - Central pipe; 9 - Spacer (air duct) middle blower nozzles, attached to the heater with clamps, to remove it you need to remove the instrument panel; 10 - Right air duct nozzle in the footwell, screwed with the heater (1.5 Nm); 11 - Air conditioning; 12 - Air distributor spacer for the rear body floor; 13 - Air distributor for the rear body floor; 14 - Rear floor air distributor tip, retained in rear floor air distributor and seat frame crossmember; 15 - Air intake grille, fixed in the rear cross member of the frame in front of the spare wheel well from the outside, the curtains must be freely movable and must close automatically, the area in front of the air intake grille must be free, otherwise the ventilation of the interior of the car would not work; 16 - Left air duct nozzle in the footwell, screwed to the central pipe support (1.5 Nm); 17 - Seal for connecting the heat exchanger in the transverse wall (mounting plate); 18 - Seal for connecting the expansion valve in the cross wall (mounting plate)
Removal and installation the middle blower nozzle
Remove the key from the ignition and turn off all electrical consumers. Carefully remove the middle air outlet nozzle, using a plastic wedge as a lever, at the location of the "arrow" locking tabs. Disconnect the plug connector from the hazard warning light switch. When installing, ensure that the fasteners are installed correctly.
Assembly position - seals
1 - Rubber seal of the cross wall and expansion valve, fastening - on the cross wall; 2 - Transverse wall (mounting plate); 3 - Foam seal for expansion valve and cross wall, glued to evaporator body; 4 - Foam seal with holder - cross wall, secured to the air conditioning unit; 5 - Condensate drain valve, installed in holder "4" and on the air conditioning unit; 6 - Rubber seal for the cross wall and condensate drain valve, fastening - on the cross wall
View the original on the website: skodabook