1 - Air conditioning wiring harness, to remove it you should carefully cut the cable clamp, when installing you should install new cable clamps in the same place; 2 - Evaporator body - upper part, connection of the upper and lower parts of the evaporator with screws and clamps; 3 - Additional resistor for the heating system fan "V124"; 4 - Foam seal, replace if damaged, self-adhesive, glued to the evaporator body, before installation, remove any remaining adhesive from the body with acetone; 5 - Expansion valve; 6 - Housing - for air intake, with a damper for fresh and circulating air, secured at the top and bottom with clamps; 7 - Self-adhesive seal, before proceeding with assembly, remove any remaining adhesive from the housing with acetone to allow air to enter; 8 - Dust and pollen filter, also as a combination filter with an odor filter; 9 - Actuator motor for regulating the flap for fresh and circulated air "V154", secured in the holder; 10 - Holder, actuator motor for regulating the damper for fresh and circulated air "V154"; 11 - Fresh air intake fan "V2"; 12 - Fresh air intake fan holder "V2"; 13 - Evaporator body - lower part; 14 - Filter cover; 15 - Lower part of the air distributor housing; 16 - Heating element of the additional resistive heater (ARH) "Z35"; 17 - Heat exchanger; 18 - Air distributor flap control device; 19 - Evaporator seal, observe the assembly position: the water drainage holes must be facing downwards; 20 - Evaporator; 21 - The upper part of the air distributor housing is connected to the lower part of the air distributor housing with brackets; 22 - Support, is an integral part of the ventral pipe, screw connection to the air conditioner and to the support of the middle panel, tightening torque on the air conditioner: 5 Nm, tightening torque on the support of the middle panel: 10 Nm; 23 - Holder, actuator motor for regulating the mixing (temperature) "V68" dampers; 24 - Actuator motor for controlling the mixing temperature flap "V68"
Air conditioner connecting parts
1 - Screw for plastic material, tightening torque: 1 Nm; 2 - Before removing the bracket, mark the position and location on the housing; when installing, ensure that the clamping part of the clamp enters the fixed position in the groove of the housing.
Expansion valve - assembly diagram
1 - Evaporator; 2 - Thermal insulation, expansion valve; 3 - O-ring, replace, 11.10 mm; 1.78 mm; 4 - Expansion valve; 5 - 5 Nm; 6 - O-ring, replace, 17.17 mm; 1.78 mm; 7 - Threaded plate
The original article is located on (www.skodabook.ru)