Important: The areas under the bushings and sliding surfaces must be lubricated with grease "G 000 450 02"
1 - Bowden cable drive for gear shifting, mounted on the gear shift lever guide; 2 - Cable drive for the pre-selective gear shift control device, to the pre-selective gear shift control crank; 3 - Cable bushing for preselective gear shift control device; 4 - Lock washer, when removing, make sure not to damage the Bowden cable drives of the gear shift; 5 - Gear shift housing; 6 - Flexible roller counter support (bowden cables); 7 - Bushing, installation of flexible roller counter support (bowden cables) on the gearbox; 8 - Spacer sleeve; 9 - 20 Nm. 3 pcs., for counter-support of flexible rollers (bowden cables); 10 - Flexible roller fixing device (bowden cable), for cable drive (Bowden) of the preselective gear shift control device; 11 - Flexible roller fixing device (bowden cable), for cable drive (Bowden) gear shifting; 12 - Retaining ring; 13 - Bushing; 14 - Preselector lever; 15 - Crawler; 16 - Gear shift lever (gearbox control lever), with a damping counterweight, install it so that the place with the gap in the teeth fits into the gear shift control shaft; after installation, the gear shift mechanism should be adjusted; 17 - 20 Nm; 18 - Retaining ring, replace after each removal
Position for assembling the gear shift lever and shift guide lever
- 1 - gear shift lever with damping counterweight
- 2 - the guide lever of the gear shift enters with its slider into the guide rail of the gear shift lever "arrow"
Article reprinted from the website [SkodaBook]