Contents: Cars without air conditioning ⬇ Cars with air conditioning ⬇ Continued for all vehicles ⬇ Installation ⬇ Tightening torques ⬇
Disconnect the battery. Remove the lower cover on the driver's side.
Cars without air conditioning
Remove the left footwell air duct nozzle.
Cars with air conditioning
Remove the left footwell air duct nozzle.
Vehicles with the central control unit for electrical equipment of the "Comfort" system "J393"
Remove the central control unit for the comfort system electrical equipment - J393-.
Continued for all vehicles
Remove the plastic nuts. Remove cover "2". Remove the brake light switch. Disconnect the plug connector from the accelerator pedal position sensor "G79". Separate the brake pedal from the brake booster.
Unscrew the pedal mechanism lock nuts. The upper pedal mechanism lock nut is not visible in the picture. It is located on the body wall separating the engine compartment from the passenger compartment, above the pedal mechanism. Remove the accelerator pedal from the pedal assembly (3 screws). Remove the pedal assembly.
Installation
Insert the pedal mechanism. Install the accelerator pedal onto the pedal assembly (3 screws). Screw on the nuts securing the pedal assembly and tighten. The upper pedal mechanism lock nut is not visible in the picture. It is located on the body wall separating the engine compartment from the passenger compartment, above the pedal mechanism. Connect the brake control pedal to the brake booster. Connect the plug connector of the accelerator pedal position sensor "G79". Adjust and install the brake light switch. Remove the lower cover on the driver's side. After installing the cover "2", tighten the plastic nuts "1". Connect the battery. Perform a vehicle system test using a diagnostic tool.
Tightening torques
| The pedal mechanism on the brake booster and on the body wall separating the engine compartment from the passenger compartment | 28 Nm |
| Accelerator pedal - pedal mechanism | 9 Nm |
[The original article is available on: SkodaBook.ru]