Important: Thanks to the automatic adjustment of the rear wheel clearance, there is no need to adjust the hand lever of the parking brake system during operation. A new adjustment must be made if the parking brake cable, disc brake caliper, friction linings or brake disc are replaced. The brake system must be bled and the brake pedal must function properly.
Release the parking brake lever. The parking brake lever is in the neutral position. Remove the storage shelf and armrest. Press the brake pedal firmly with your foot at least three times. Tighten and release the parking brake lever three times. Tighten the adjusting nut "A" to such an extent that the levers on the disc brake calipers are raised, pulling away from the stop surfaces "arrow B".
Important: The adjusting nut "arrow A" must be screwed through the end of the rod.
Check the distance "a" between the lever and the stop surface on the left and right calipers of the disc wheel brake mechanism using feeler gauges. If the parking brake lever is released, then the sum of the distances "a" (between the lever and the stop) the gap between the left and right disc brake calipers should be no less than 1 mm and no more than 4 mm. The gap on one side should not exceed 3 mm.
Tighten and release the parking brake lever three times. As a result of the above, the parts will sit properly in their position. Loosen the parking brake lever and check that both wheels turn freely. If necessary, slightly loosen the adjusting nut and repeat the "a" measurement. Install the storage shelf and armrest.
(The article is located on the website: www.SKODABOOK.ru)