Removal and installation the crankshaft 1 - Bearing inserts 1,2,4 and 5-, for bearing caps without lubrication grooves, for cylinder blocks with lubrication grooves, do not mix up already used bearing inserts (mark); 2 - 65 Nm + 1/4 turn (90°), replace, through thread; 3 - Bearing cover, bearing caps 1: on the pulley side, bearing cap 3: with a recess for friction rings, the retaining lugs of the bearing shells in the cylinder block and in the bearing caps must overlap each other; 4 - Bearing insert 3, for bearing cap without lubrication groove, for cylinder block with lubrication groove; 5 - Guide ring, for bearing cap 3, ensure locking; 6 - Sensor wheel, for engine shaft speed sensor "G28"; 7 - 10 Nm + turn 1/4 turn (90°), replace; 8 - Finger, control of excess over crankshaft; 9 - Crankshaft, main bearing journal diameter: 54.00 mm, connecting rod bearing journal diameter: 47.80 mm, axial clearance of a new part: 0.07-0.17 mm, wear limit: 0.37 mm; 10 - Guide ring, for cylinder block, bearing 3
Checking the pin overhang over the crankshaft
Use a depth gauge to check the excess "a" of the pin with the impulse wheel "1" removed.
- 1 - Impulse wheel
- 2 - Support screw
- 3 - Excess of pin "3" over crankshaft "a" = 2.5-3.0 mm